How a Battery Functions

NOTE: Unless otherwise indicated, illustrations used in the procedure are for LHD model.

NOTE: The LaneWatch camera must be aimed after one or more of the following procedures are done:

• －LaneWatch camera removal or replacement
• －Passenger's power mirror removal or replacement
• －Passenger's door panel body repair
• －Passenger's door position adjustment

Set up the vehicle:

• －Make sure there are no other objects except the aiming target in this area.
• －Check the tyre pressures, and adjust them to the specified value if needed.
• －Put a person or an object equivalent to the driver's weight in the driver's seat.
• －Park the vehicle on level ground in a wide open area to avoid any reflection from objects that could affect the alignment procedure. Make sure you have at least the following amount of space around the vehicle: 6.5 m (21.3 ft) in length, 3.5 m (11.5 ft) in width.
• －Install the aiming target on the passenger's side of the vehicle.
• －Do the aiming in a proper place where you can obtain about 4.5 m (14.8 ft) distance between the target pattern and the vehicle (from the center of the front wheel hub).

NOTE: When marking on the floor surface, use suitable tape to mark the exact locations.

Prepare these items:

• Tape measure and ruler
• Felt-tip pen
• Tape
• String

1. Marking of the Target Position - Set

Preconditions

• Transmission P Position/Mode
• Parking Brake Applied
  

Procedure/Specifications

1. Make spots (Z1, Y1, Z2, and Y2) and set a string along the center-line of the vehicle.
2. Place a string (a) between point Z1 and point Y1, and tape both ends of the string on the floor surface. (Figure 1)
3. Measure and make a new spot V1 on the floor surface in rear of the vehicle from the point Z1. (Figure 1)

NOTE: Repeat this step for the opposite side for points Z2 and Y2. (Figure 1)
NOTE: Repeat this step for the opposite side, and mark a new spot V2. (Figure 1)

Distance Specifications (Figure 1)

4. Stretch a string (c) between point V1 and point V2, and tape both ends of the string on the floor surface. Mark a new point U where the string crosses with the center-line (d). (Figure 2)

5. On the string, measure and make a new spot V3 on the floor surface in passenger's side from the point U. (Figure 2)

Distance Specifications (Figure 2)

6. Set the aiming marker A and B to the LaneWatch aiming stand set, and adjust the height of the aiming marker. (Figure 3)

Specifications (Figure 3)

7. Place the left side edge of the aiming marker on point V3 that you made in the previous step. Align the legs of the marker with the string to make sure the marker is square to the vehicle. (Figure 4)

2. LaneWatch Camera - Aim

• Procedure/Specifications

NOTE:

• To stop the aiming procedure, turn the vehicle to the OFF (LOCK) mode.
• If you press the LaneWatch switch while in the aiming mode, the current aiming data will be cleared.

1. Start the LaneWatch camera aiming.
2. Press the LaneWatch switch on the end of the turn signal switch to aim the camera.

• Result

If the aiming has failed, you must start the LaneWatch camera aiming procedure again.
If LaneWatch camera aiming status is OK, turn the vehicle to the OFF (LOCK) mode.