DTC B0010-13: Open or Increased Resistance in the Front Passenger's Airbag First Inflator

DTC B0010-13 Overview

If a voltage on the detection line inside the SRS unit is higher than a specified value, the SRS unit determines an abnormality and stores the DTC.

Inspection Outline

The components to be tested are indicated by a dotted line.

Inspection Items

NOTICE:

Before disconnecting the SRS related connector, do the 12 volt battery terminal disconnection procedure and wait for at least 3 minutes.

NOTE:

Since there is no direct method to test the component itself, troubleshooting is performed on the related components.

Front passenger's airbag circuit inspection

Preparation

－Front passenger's airbag inflator 4P connector: disconnected

Procedure

Install a jumper wire between front passenger's airbag inflator 4P connector terminals No. 2 and No. 3.
Perform the confirmation procedure.

Normal Conditions

－DTC B0010-13 is not indicated.

If it is normal, there is a problem with the front passenger's airbag.
If it is abnormal, there is a problem with other related components.

Preparation

Procedure

－Perform the inspection according to the following table.

If abnormal, there is a problem in the circuit.

If the other inspection item(s) indicated a normal condition, then it is determined that the remaining SRS unit is the cause.

There is a problem with the SRS unit.

Turn the vehicle to the ON mode, then wait for 10 seconds.